MNE175STM-L
Gray steel with 175a/125VDC inverter breaker
Shipping: 18 X 11 X 28” 39 Lb.
MNE250STM-L
Gray steel with 250a breaker for MS4024/ MS2812
Shipping: 18 X 11 X 28” 39 Lb.
MNE125STMM-L
Designed for the Magnum Energy MM series inverters. These steel left hand units come with pre-wired AC bypass and AC input, 125 amp inverter battery breaker, AC input and output busbars, PV+ input busbar, 80 amp Battery + busbar, battery- busbar, chassis ground busbar, 500 amp shunt, charge control bracket, 2AWG inverter DC cables, mounting hole in door for MMRC control panel, din rails for 6 additional AC or DC breakers, knock outs for 3 panel mount breakers, GFCI knockout, mounting brackets,
MNE250ALM-L
White aluminum with 250a breaker for MS4024/MS2812
Shipping: 18 x 11 x 28 31 Lbs.
MNErightdoorSTM
Gray steel right hand hinge door with LH charge control braket for wide chassis
The Magnum E-Panel comes with inverter breaker, 2/0 inverter cables, pre-wired AC input and bypass, 500amp 50mV shunt, AC terminal blocks, 100 amp DC positive and DC negative bus bars, PV input bus bar, din rails, 3 panel mount breaker knockouts, Ground bus bar, DC wiring cover, top shield, remote display mounting bracket, wall mounting brackets, charge controller bracket and lots of hardware and grommets.
The picture left shows a 120VAC Magnum E-Panel wired with an AC input/output and PV lightning arrestor, two 80 amp panel mount charge control breakers, the Magnum remote display and MPPT charge control bracket in place. Note that panel mount breakers exit the opposite side as din rail mount breakers. The Magnum ME-BMK-NS is easily mounted directly adjacent to the internal 500 amp shunt. Add a 2 amp breaker to power Magnum battery status monitor (ME-BMK-NS).
ETL listed for the US and Canada
| Back to Balance of System |
